If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How would i go about fixing an mtech 1 rear spoiler?
How would i go about fixing an mtech 1 rear spoiler?
While I was removing the screws, the two nuts inside came out of its hole and pretty much destroy the surrounding area. Are there any liquid molding strong enough to hold the nut back into its place? Will JB weld do the trick? thanks in advance.
