Hey everyone, I'm starting to look into doing a non-E30 cluster swap and looking for some help.
I am trying to get everything to a point were as much of it is plug and play as possible so i am trying to make pigtails with the cluster connectors. I found somewhere to source the connectors but the back side is obviously a solder to board type of connection.
My question is, whats the easiest way to get wire leads connected to each of the pins? I would use these to solder together the non-bmw cluster pigtials together but trying to find a way to do it with out soldering to every single pin.
Maybe thats not possible but i dont know all the various ways (if any) to connect to the connector and Im hoping someone with more electrical knowledge can help.
I am trying to get everything to a point were as much of it is plug and play as possible so i am trying to make pigtails with the cluster connectors. I found somewhere to source the connectors but the back side is obviously a solder to board type of connection.
My question is, whats the easiest way to get wire leads connected to each of the pins? I would use these to solder together the non-bmw cluster pigtials together but trying to find a way to do it with out soldering to every single pin.
Maybe thats not possible but i dont know all the various ways (if any) to connect to the connector and Im hoping someone with more electrical knowledge can help.