Superultrahippo's mini audio build

[superultrahippo]

Shoud do fine mounting it there - maybe a little higher so things don't roll into it and scratch the amp.
If its small enough you could put it over in the area above the jack in the trunk. or over the battery.
Drill the box on whatever side of the trunk that you mount the amp. If in the middle then on the side that the speaker wires attach to the amp.

yea, ill have to figure something out tomorrow. I def want all the wiring out of sight.

[superultrahippo]

You cut that with a DREMEL?

You are nucking futz, man...carry on.

Would you take some incredibly detailed shots of the amp? From what I can tell, it is the same manufacturer as the Titanium Power I sell. What did you pay for it?

I almost shit myself a couple times thinking that bit would fly into my eye.

attatched a couple pics.. camera sucks. Paid 110..free shipping. I got the last one off the website though. Says it's on backorder now..

[StereoInstaller1]

Oh yeah...I am tripping on how quick you got that. Everyone else will be in a day or three, except the one that went to Germany.

[Serious Sam]

Shoud do fine mounting it there - maybe a little higher so things don't roll into it and scratch the amp.
If its small enough you could put it over in the area above the jack in the trunk. or over the battery.
Drill the box on whatever side of the trunk that you mount the amp. If in the middle then on the side that the speaker wires attach to the amp.

[StereoInstaller1]

You cut that with a DREMEL?

You are nucking futz, man...carry on.

Would you take some incredibly detailed shots of the amp? From what I can tell, it is the same manufacturer as the Titanium Power I sell. What did you pay for it?

[superultrahippo]

Not really a build actually, just a sub/amp but whatevers.

..got my box from Luke Friday. The rest of my equipment came in today so I figured I'd get a head start on everything. Equipment is as follows..(I was on a budget!)

Alpine CDA-105 (running all 4 speakers from fader)
MB Quart RAB 1450 Mono AMP
Kenwood KFC-W2512 4ohm sub
10' box from luke
e2 E400 Amp wiring kit (20 bucks..read good reviews)


As I got home this huge box was awaiting for me. And yes, i giggled like a schoolgirl..


..upon further investigation



Then proceeded to make the backpanel from lukes template and carpet. I was going to op for 1/8 hardboard but seemed really flimsy. Ended up getting 1/4 thick for about 5 bucks from home depot.



Shit, how am I going to cut this out? Well it was either cough up 30+ bucks for a cheap jig saw or macgyver my way out of this hiccup. Ah yes I have a DREMEL! Trip to the hardware store and I found a wood bit.. god help me.

After causing tonz of noise ..not bad eh?



All done.. I used 3M adhesive spray for the carpet. Got rather light headed but it came out rather nice.




Well hello there.. dont mind if I do.





Anyways.. suggestions on how I should mount the amp? Cant really decide. Also wanted to know where I should drill for the sub wiring? ..other than convenience, does it really matter? Thoughts on equipment? ..I went of pricing and reviews mostly.