Announcement

Collapse
No announcement yet.

Need help getting specs...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Need help getting specs...

    From what Ken told me about 11 months ago, I know that the amp/crossover combo that came in a car I bought is pretty good, although very old.
    I need help finding the specs on this equipment. I emailed a/d/s, but they haven't replied yet. I finally yanked the whole system out, and here's what I have:

    -a/d/s PH15 6-channel amp. Ken originally mentioned something like 60watts rms @ 4 ohms. Any other info?

    -a/d/s 642CSi "Crossover, Signal Processor, Interface Adaptor".

    -KLW Audio Image Enchance XA-23 Ambient Frequency Processor (attached to back of the 642CSi)

    -MB Quart QM 210K, crossovers? Wired between the amp and the rear speakers. Only German on one, and mostly German/some English on the second:
    "Original 12dB Frequenzweiche
    Power handling 80/100W
    Frequency range 35-32000Hz
    Impedance 4ohm
    Please pay attention to the alternative tweeter point!"

    I also have two a/d/s S10 subwoofers (numbered 2060369, dated 1989).

    I know practically nothing about car audio, except that new components are grossly overpriced. I would eventually like to have a very tight sounding audio system in my car. I care about quality over volume/huge bass. This system seems to have been installed around the time the car was bought new (1990). Is what I have still excellent quality by today's standards? Or am I better off selling this stuff to an old-school car audio aficianado and just buying new components? Thanks for any help at all. I'll try to get pics of everything this week.
Working...
X