Announcement

Collapse
No announcement yet.

need to roll up windows but engine and wiring harness out

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    need to roll up windows but engine and wiring harness out

    noob here, i am in the middle of rebuilding bottom to top and now that the engine/trans and wiring (c101) is all out. is there a way i can get power to the switches to roll up the windows?

    #2
    If there's a plastic plug on your door panels you can manually crank them up through that hole. You may need the plastic tool that's probably not in your tool kit
    Deck Lid and soft top Shocks on hand

    Seat shocks on hand for immediate shipment
    https://www.r3vlimited.com/board/sho...86#post4944786
    Alice the Time Capsule
    http://www.r3vlimited.com/board/showthread.php?t=360504
    87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220

    Comment


      #3
      I had to do this recently and just grabbed the my cordless drill battery and jumped some wires from the switch.



      Looks like this shows violet and black for the driver side and violet/gray and black/gray for the passenger. Just try any polarity and it if rolls up, cool. If not, swap polarity.
      1984 325e m50nv/G260
      1991 325i Mortdecai the pickup project
      1991 Trans Am turboLSx/t56
      1984 Husqvarna Abomination

      Comment


        #4
        https://www.r3vlimited.com/board/sho...d.php?t=428800


        it's a Kenny Powers quote on wheels

        Comment


          #5
          You can send 12 volts directly to the motors too. One polarity up and one down.
          Owner - Bavarian Restoration
          BMW and European Electronics Repair and Restoration
          www.BavRest.com
          My Feedback Thread
          Our Facebook!
          Follow our Instagram!

          Comment

          Working...
          X