I need help diagnosing my ABS system, so I can get my ABS working.
So, I jumped the pump, and it runs front and rear.
If I pull a relay the ABS light on the dash comes on.
I have two computers and they both work the same.
I tested each sensor individually by only having one plugged in and going for a drive. By this method, both front sensors test good.
This is where I'm stumped
With the LR sensor only plugged in, I get no ABS light With the RR sensor only plugged in, I get no ABS light.
With both of them plugged in, and no front sensor plugged in, I get a light on the dash.
I OHM'd both sensors, and they both test at 1k OHM.
I checked the continuity from the sensors to the computer harness, it's good.
So, I'm wondering if I possibly have the wrong sensors, or if they could possibly be bad either way. I got the sensors used, but they were advertised as 'good'
Before I go ordering parts, I wanted to ask if there's anything more I can check.
So, I jumped the pump, and it runs front and rear.
If I pull a relay the ABS light on the dash comes on.
I have two computers and they both work the same.
I tested each sensor individually by only having one plugged in and going for a drive. By this method, both front sensors test good.
This is where I'm stumped
With the LR sensor only plugged in, I get no ABS light With the RR sensor only plugged in, I get no ABS light.
With both of them plugged in, and no front sensor plugged in, I get a light on the dash.
I OHM'd both sensors, and they both test at 1k OHM.
I checked the continuity from the sensors to the computer harness, it's good.
So, I'm wondering if I possibly have the wrong sensors, or if they could possibly be bad either way. I got the sensors used, but they were advertised as 'good'
Before I go ordering parts, I wanted to ask if there's anything more I can check.
Comment