Building my MS2 box right now, and I am going to be using wasted spark. I would like to mount the 2 extra drivers in the positions of R37 and R38.
Since r37 and r38 aren't to be bolted to the heat sink, I am curious if I would have a problem mounting them to the bottom side of the board. This way I don't have to worry about any problems down the road from not using the resistors for protection.
Edit: Looks like r37 and r38 are aren't going to cause an issue as long as I don't do anything stupid... So I'm just going to jumper them. It will be a while before the car is completely together though, so input will still be read and considered.
Thank you.
Since r37 and r38 aren't to be bolted to the heat sink, I am curious if I would have a problem mounting them to the bottom side of the board. This way I don't have to worry about any problems down the road from not using the resistors for protection.
Edit: Looks like r37 and r38 are aren't going to cause an issue as long as I don't do anything stupid... So I'm just going to jumper them. It will be a while before the car is completely together though, so input will still be read and considered.
Thank you.