86 325e 325i engine harness question!

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • dirty thirty
    replied
    you have the wire on the left connected to the stud on top of the starter?
    where do the two othere wires that come out of the starter relay go

    Originally posted by Bretts85E30
    That would be my best guess there are 2 posts on my early eta starter but i only have the shrouded wire on the left that connects to the solenoid on the top

    Leave a comment:


  • Bretts85E30
    replied
    That would be my best guess there are 2 posts on my early eta starter but i only have the shrouded wire on the left that connects to the solenoid on the top

    Leave a comment:


  • dirty thirty
    replied


    Do bolth of these go on the two post on the starter soleniod.

    Leave a comment:


  • dirty thirty
    replied
    Thank you i got it now !
    Originally posted by Bretts85E30
    Far as i know the only wires that goto the starter power and ground wise connect directly to the solenoid and the ground mounts directly to the frame or block whichevers easier

    Leave a comment:


  • e30trooper
    replied

    Leave a comment:


  • Bretts85E30
    replied
    Far as i know the only wires that goto the starter power and ground wise connect directly to the solenoid and the ground mounts directly to the frame or block whichevers easier

    Leave a comment:


  • dirty thirty
    replied
    Now i have the big black wire from battery pos on the wire wall and the red positive cable coming from the loom hooked up to the starter soleniod. there is a blck ground wirte that runs in the loom next tot the small red starter wire. where does this black ground cable connect to on the starter?

    Leave a comment:


  • dirty thirty
    replied
    Does any one have a pic of the starter installed in vehicle ?

    Leave a comment:


  • BavBeater85
    replied
    that sucks, my i motor came with the wiring harness till hooked up, even the starter was still on the engine and wired

    Leave a comment:


  • BavBeater85
    replied
    starter should have different sized studs, so youll be able to match by eye if you have the right ones running to it

    Leave a comment:


  • dirty thirty
    replied
    The big wire for the starter goes where on it ?

    Leave a comment:


  • dirty thirty
    replied
    Originally posted by Cronopoulos
    I would say you are correct here.
    Were on the starter? The back?

    Leave a comment:


  • dirty thirty
    replied
    the car is an 86 and the harness is a 91 380 ecu

    Leave a comment:


  • Cronopoulos
    replied
    I would say you are correct here.

    Next the big black cable coming from battery+ where does this go, the starter?

    Leave a comment:


  • e30trooper
    replied
    the two ground wires ground out on the battery tray.

    what year is your car and what year is that harness from?

    Leave a comment:

Working...