valve lash, vacuum leaks?
16 MPG? Suggestions?
Collapse
X
-
I wouldn't mess with the AFM yourself unless you know what you're doing. Did you pull the spark plugs to check the mixture?Leave a comment:
-
This has me. Thinking....Although I am very hesitant to mess with the AFM. Shoul I try adjusting the screw to lean her out a bit?I'm assuming it's an M20B25? I would check for vacuum leaks by getting a smoke test done or at the least inspecting the lines for hardness or cracking. If you haven't adjusted the valves in a while that should be done anyway, and I would see if any PO's have messed with the AFM or not. Also, the automatic trans will hurt mileage a little but doesn't account for all of that.Leave a comment:
-
Mine is bone stock...so I should take apart and clean the air flow meter?Leave a comment:
-
You have an air flow meter though don't you? Clean it with some carburetor cleaner. Take of you air box, run the car and spray some in whole revving.
I ment I actually changed my afm to a maf sensor. It's works fine but will that upgrade affect mpg's ?Leave a comment:
-
-
-
Should the FPR be suspect? I'm assuming at this point it has to be running rich...Leave a comment:
-
Thanks guys. Yea, it's an m20b25
Other new parts:
New o2 sensor
New cat converter
Bought this thing for cheap commuting, and so far it's been anything but...Leave a comment:
-
Sorry to thread jack but I'm in the same boat. Would a maf affect mpg's.
I'm subscribing to this thread because I need yo up my mpg's alsoLeave a comment:
-
I'm assuming it's an M20B25? I would check for vacuum leaks by getting a smoke test done or at the least inspecting the lines for hardness or cracking. If you haven't adjusted the valves in a while that should be done anyway, and I would see if any PO's have messed with the AFM or not. Also, the automatic trans will hurt mileage a little but doesn't account for all of that.Leave a comment:
-
dragging brakes, old hub bearings, gummed up injectors, bad O2 sensor, valves need to be adjusted, timing is off a tooth..Leave a comment:

Leave a comment: