need help asap

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jw 325ic
    E30 Fanatic
    • Sep 2006
    • 1360

    #1

    need help asap

    So I went to a junkyard, got a tranny. Was supposed to be a g260, owner even said it was a 325i tranny. Ive never seen a g260 out so I assumed this getrag tranny was fine. Pulled my tranny out, and cleaned up the junkyard one, noticed it said "318i" on it. Well...shit. Read on here a g240 would fit and work so we bolted it up. Well it was twisted over to the drivers side and the shifter wouldnt get to reverse.

    We tried manipulating it but no luck. So we went to pull the 240 out and put the 260 in (no 2nd gear) and now the 240 wont come out. We tried prying for hours. We're about to tie a wench to it...any tips before we do that?

    We're guessing the pilot bearing may be stuck on the trans input shaft. I have a replacement bearing but i just put a new clutch disc in there so any advice is much appreciated. Thanks.
Working...