Announcement

Collapse
No announcement yet.

Bmw Oem part avail to mount zf6 speed transmission (2005+) into e30

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    Sweet bump! Didn't see this the first go around.

    SILBER COMBAT UNIT DELTA (M-Technic Marshal)
    RTFM:http://www.r3vlimited.com/board/showthread.php?t=56950

    Comment


      #32
      Pm sent I have a couple questions on what flywheel and clutch to use on my S54 Zf 6 speed swap

      Comment


        #33
        Originally posted by 89AlpineM3 View Post
        Pm sent I have a couple questions on what flywheel and clutch to use on my S54 Zf 6 speed swap
        The fly and clutch data is pretty common; s54 is not special anything works that matches the trans.

        There is a vin number on the tranny if you are wondering what mates with it.

        Garagstatic makes a part to extend the transmission mount; call them and buy it.
        OBD1 M54/M52TU swap as a M50b25

        Z4 non powered steering rack fits e30



        Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

        Comment


          #34
          Thank you for the info

          Comment


            #35
            What options do i have for clutch and flywheel if i wanted to install the gs5-53bz out of the 335i onto a s52? Will the flywheel off a e36 work? Are there any issues with the install due to the input shaft being inverted?

            Comment


              #36
              Woah

              Seriously

              How have I not seen this until now?
              Pictures of the full setup installed?

              Comment


                #37
                hi
                wellcome to this forum sites here you can find lots of thing i suggest you for problem you have to contact any other expert know i have no knowledge about your question sorry for that.......
                --------------------
                top ten classified websites

                Comment


                  #38
                  Originally posted by Bay_bmw View Post
                  What options do i have for clutch and flywheel if i wanted to install the gs5-53bz out of the 335i onto a s52? Will the flywheel off a e36 work? Are there any issues with the install due to the input shaft being inverted?
                  2008.5+ have the pilot bearing Inside the input shaft.

                  No go for older car swaps ( at least not easily due to flywheels avail from bmw)

                  The e60 part obviously needs a custom brace to go with it to match e30 body; this is stated and obvious.

                  Sent from my SAMSUNG-SGH-I337 using Tapatalk
                  OBD1 M54/M52TU swap as a M50b25

                  Z4 non powered steering rack fits e30



                  Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

                  Comment


                    #39
                    E30/S52 + e46 M3 6-speed. I just buy the two parts you show in the first post and I'm golden?
                    S52-Powered 1987
                    sigpic

                    Comment


                      #40
                      You need to read.

                      Sent from my SAMSUNG-SGH-I337 using Tapatalk
                      OBD1 M54/M52TU swap as a M50b25

                      Z4 non powered steering rack fits e30



                      Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

                      Comment


                        #41
                        Oh cock and balls. I just finished this swap with fabricated braces. Could have saved myself quite a bit of headache!
                        1989 325is - 2000 323it - 1990 M3 - 1973 2002 - 1975 CB550F

                        Troll my Instagram feed: m.carey

                        Comment


                          #42
                          Originally posted by Wanganstyle View Post
                          You need to read.

                          Sent from my SAMSUNG-SGH-I337 using Tapatalk
                          Well, you see, I did read, but nowhere does anybody use the letter-number combo "M3" in a post on this thread. That's why I asked the question. The M3 trans is different, and I'm unclear if the rear mounts are different. Also, I can't tell from your pics whether you have to use a modified e30 rear cross-member, something different entirely, the stock one with wings, or just stock.
                          S52-Powered 1987
                          sigpic

                          Comment


                            #43
                            Originally posted by Curt Hayes View Post
                            Well, you see, I did read, but nowhere does anybody use the letter-number combo "M3" in a post on this thread. That's why I asked the question. The M3 trans is different, and I'm unclear if the rear mounts are different. Also, I can't tell from your pics whether you have to use a modified e30 rear cross-member, something different entirely, the stock one with wings, or just stock.
                            Title of thread:

                            Bmw Oem part avail to mount zf6 speed transmission (2005+) into e30

                            Here are 2 questions that only you can answer:

                            Is your E46 M3 transmission a ZF?
                            Did you even look at the item you purchased? Usually ........USUALLY the BRAND of make is on the actual gearbox
                            OBD1 M54/M52TU swap as a M50b25

                            Z4 non powered steering rack fits e30



                            Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

                            Comment


                              #44
                              Originally posted by Wanganstyle View Post
                              Title of thread:

                              Bmw Oem part avail to mount zf6 speed transmission (2005+) into e30

                              Here are 2 questions that only you can answer:

                              Is your E46 M3 transmission a ZF?
                              Did you even look at the item you purchased? Usually ........USUALLY the BRAND of make is on the actual gearbox
                              What you mean I have to read the title too? D'oh!
                              No, it'll be a getrag. Guess I'll have to buy a custom.
                              S52-Powered 1987
                              sigpic

                              Comment


                                #45
                                Originally posted by Curt Hayes View Post
                                What you mean I have to read the title too? D'oh!
                                No, it'll be a getrag. Guess I'll have to buy a custom.
                                Garagestatic website sells the adapter you need for your getrag
                                OBD1 M54/M52TU swap as a M50b25

                                Z4 non powered steering rack fits e30



                                Euro e46 2005/6 320d 6mt gearbox into E30 with M20 hardy and beck 1985 327s engine

                                Comment

                                Working...
                                X