HELP! Leaky input shaft is an understatement

**vtechnik** · 10-01-2018, 09:04 PM

So I finished my manual swap today and when I gave it a test drive I noticed a steady drizzle of transmission fluid coming from the bell housing. I replaced both my input shaft seal and my rear main seal. I used this for my input shaft seal housing

Silicone Gasket Maker - Elring 510.031

https://www.fcpeuro.com/products/gasket-maker-chemical-sealant-1161059?ads_cmpid=1578517119&ads_adid=58598379734&ads_matchtype=&ads_network=g&ads_creative=296551517485&utm_term=&ads_targetid=pla-293946777986&utm_campaign=&utm_source=adwords&utm_medium=ppc&ttv=2&gclid=Cj0KCQjwi8fdBRCVARIsAEkDvnLUDkFOxtzczGkGgDvD4yVtUc-mo_uSZkFvwwUicFmIQL3gjjMil2gaAujFEALw_wcB

Silicone Gasket Maker - Elring 510.031

I spread an even thiiiiin layer on the housing and torqued it down. I made sure to get rid of all the green sealant that was already there, and I made sure the surface was like new in terms of cleanliness. Here's the seal housing I'm talking about:

I'm going to pull the transmission next week but if anyone has any suggestions or past experiences, let me know :D