Just finished putting new Febi CSB, dust caps, and snap ring on driveshaft today. All went on easy with pvc pipe and light tapping on inner race. Once bottomed out though the bearing doesn't spin freely. Feels like forward dust cap and bearing are binding together or the outer rubber is binding on forward dust cap.
If I hit I with a little WD40, it spins a little easier, but still not freely.
Is the forward dust cap supposed to go on all the way towards the universal or just on the ridge past where the CSB stops?
If I hit I with a little WD40, it spins a little easier, but still not freely.
Is the forward dust cap supposed to go on all the way towards the universal or just on the ridge past where the CSB stops?