Hello,
Long-time browser, first time poster.
I searched high and low for this on the board as well as the Bentley with no success.
Im installing a new "door" latch for my convertible, the one that releases each side of the top cover.
It seems one of the cables comes out further at the latch, in other words its a tad longer than the other cable. And when I hook up both of the cables and try to use it only one side pops as a result.
Is there a way to adjust the length of the cable?
The cable that is a tad longer is for the pass/side latch that wraps around that whole back end and over to the d/s where the handle is.
Thanks!
Long-time browser, first time poster.
I searched high and low for this on the board as well as the Bentley with no success.
Im installing a new "door" latch for my convertible, the one that releases each side of the top cover.
It seems one of the cables comes out further at the latch, in other words its a tad longer than the other cable. And when I hook up both of the cables and try to use it only one side pops as a result.
Is there a way to adjust the length of the cable?
The cable that is a tad longer is for the pass/side latch that wraps around that whole back end and over to the d/s where the handle is.
Thanks!
Comment