speedmeter, mpg meter, and radio problem

[Ferdinand]

Other than the fuses, here's something else to check.

When you unplug the connectors from the instrument cluster you have to take care to pull them straight off, not twist them or rock them from side-to-side. If you wiggle them it stresses the pins at either end of the connectors.

I had an issue with my speedo and OBC intermittently cutting out. Power comes to the speedometer from Fuse-12 to Pin-13 on the 26-pin C2 connector (the White connector on back of the instrument cluster). Pin-13 is the topmost-left pin marked in red here:



Follow that trace along the circuit board to the bottom-most pin of the connector into which the speedometer is plugged. Power is fed to the speedo through that pin, then continues along the green trace to Pin-13 on the 26-pin C3 connector (the Yellow connector on back of the instrument cluster), and from there out to the OBC.



Below is an (unfortunately blurry) closeup of what this pin looked like. Note the green arrow points to where the solder joint is cracked. That pin was loose and could be wiggled back and forth, a direct result of too much force being used to remove the Yellow 26-pin C3 connector.



You can't see it in the photos, but when I had a closer look at the pin in the topmost photo, at the start of the red trace, its solder joint had a hairline crack as well.

The solution is to use a soldering gun to reflow the solder joints to ensure a good connection. Thereafter treat the connectors with care when unplugging them.

I don't know for sure whether this is the cause of your issues, but it's worth taking a look.

[e30BMart]

nope. odometer, speedometer, mpg meter and stereo is still dead. i need some help figuring how fast i'm driving. if i'm at 2000rpm in 5 gear how fast am i driving?

2000 rpm in 5 is around 50-60 kph 3000rpm in 5 is around 100-110 kph
I know cuz my speedo doesn't work either.. and I use a gps now
(changing my speedo wire now, need to know which one is positive and which one is negative) ??

[M4DE30]

oh shit i didnt know there was a 2nd page :yawn:

[mr.vang]

unplug the alarm and see what happens!

problem fixed already^ thanks for the input anyway

[M4DE30]

unplug the alarm and see what happens!

[mr.vang]

did you check the speed sensor at the differential. the wires may not be connected or change the sensor at the differentials

thanks mate but i already found the problem^(change fuse number)

[nirenandrews]

did you check the speed sensor at the differential. the wires may not be connected or change the sensor at the differentials

[mr.vang]

updated: i replace fuse 21(previous owner put in a 10) to a 7.5 and now everything is working again, just that the speedometer get stuck sometimes and you have to tap on have cluster. so far i been driving it for the whole day and still working.

[Curt Hayes]

update: i found out the aftermarket alarm is connect to fuse 21. Also, today i was driving and out of no where everything was working again, but its dead again. the good news is that my gauge is not broken and the bad news is that, there is an electrical problem.

Well, I'd say you have a lose connection somewhere. If it were me I'd pull anything extra off fuse 21 and check it all out.

[mr.vang]

updated: fuse 21 was suppose to be 7.5 but the previous owner put in a 10a fuse. i have a bad feeling something is blown instead of the fuse.

[mr.vang]

bump?

[mr.vang]

bump?

[mr.vang]

update: i found out the aftermarket alarm is connect to fuse 21. Also, today i was driving and out of no where everything was working again, but its dead again. the good news is that my gauge is not broken and the bad news is that, there is an electrical problem.

[mr.vang]

yeah the fuel gauge. i have pull the cluster out more then 6 times. everything is plug in tight. no, i didn't touch any fuse until those were out.

[Curt Hayes]

after i change the brake fluid and fix my gas meter the speedmeter, mpgmeter and radio doesn't work anymore

By "gas meter", do you mean the fuel gauge? Sounds like you had the gauge cluster out? I'd start by pulling it again and making sure it's all plugged in properly.
Also, did you put a meter across fuse 21, or just eyeball it?