does this look safe to you?

[NC325iC]

level surface?

[bostonbmw]

I would make sure the jack stands are at the same spot on each side of the car.Length wise they should mirror each other. And get some wheel chocks

[hendrixvodu]

borbet type CA's?

[Sean]

You'll have a hell of a time getting these motor out using a cherry picker on a slanted surface. That would really suck.

[Dave]

Looks like a slight downslope - I'd get some real chocks.

[gazellebeigem3]

Better yet, get two more jack stands. They will eliminate any tendency of the car to move and give you more working room.

If its a level surface, i cant tell from the pic.

[Jean]

Two more jack stands ftw

[jlevie]

Better yet, get two more jack stands. They will eliminate any tendency of the car to move and give you more working room.

[george graves]

Loose the cinderblocks, All they will do is slide. Get some wheel chocks. Walmart, less than $20 for two nice plastic blocks.

[Dave]

ah - I see them now.

[Teaguer]

I'd like to see some damn good chocks behind the rear wheels - other than that - looks good.

He's using cinder blocks mang . ;)

[Dave]

I'd like to see some damn good chocks behind the rear wheels - other than that - looks good.

[Teaguer]

Looks perfectly safe .
Wheels are chocked which is good and jack stands are OK ...could be a little more forward but they are fine .

It would look a lot better if you toss those Tempo whels in the trash though . :D

[Sean T Sat]

Ok so im doin an engine swap for the first time and im a little nervous about bein under a car so tell me does this look safe to you?