Hey guys,
I'm about in install the camber and toe adjustment kit I got off e30 tech on my car. I am ready to take it to a welder, but I would like to find out what setup I should look for to ensure the job is done properly and the welds hold up. My knowledge about welding is minimal, so some insight would help out a lot. What would ensure the job is done right?
Sorry if this question has been answered already.
I'm about in install the camber and toe adjustment kit I got off e30 tech on my car. I am ready to take it to a welder, but I would like to find out what setup I should look for to ensure the job is done properly and the welds hold up. My knowledge about welding is minimal, so some insight would help out a lot. What would ensure the job is done right?
Sorry if this question has been answered already.
