My Over Voltage Protection of the ABS system keeps blowing the internal fuse immediately after I turn the key to the on position. I have a spare ABS control unit and it seems to be the same as far as which pins are grounded and which are not. I have the wiring diagram but not sure where to start.
Announcement
Collapse
No announcement yet.
Over Voltage Protection/ABS Issue
Collapse
X
-
I am still having ABS issues with my 1989 325I. I have an ABS light constantly on. Found the Over Voltage relay fuseable link melted. Wired in a external fuse 7.5A in place of the melted one. Once I pluged the Over Voltage relay back into the harness it popped the breaker immediately. It sounds like a short somewhere. I tried looking at the ETM and did not see a very good pin out diagram as to where to start. I do have a spare control box and they seem to have the same open and resistance by going pin to ground or pin to pin while checking disconnected.sigpic
Steve Corbett
1983 528E Scrapped
1983 528E Sold
1984 745I
1984 325E - Sold
1989 325I Bronzit-Sold
1989 325I Zinno
1988 635CSI
Comment
Comment