REAR end noise after installing spring/shox
Collapse
X
-
Is your rear end full of fluid since you replaced the axles. If so then the bearings are now trashed. -
The camber of a wheel isn't going to cause any sort of noise or vibration issues unless you are rubbingLeave a comment:
-
yes it does..thought it may have been from the camber of the rear tires now,sitting to low,but i just raised it up 10mm...still have the noiseLeave a comment:
-
anyone....I think i need to raise the rear a tad.maybe 10mm...wheres the best place to get spring pads?Leave a comment:
-
REAR end noise after installing spring/shox
Ok, just installed billys/sport spring and i am hearing noise from rear end.sounds like a stone in tire noise..new tires and new CV joints,but still that damn annoying noise,cant really feel it though! only thing i can think of is maybe since i lowered it a inch or so,that the CV joint are now compressing on the rear end causing the noise.
I didnt have this noise untill i installed the spings/shox....any ideas???
thanksTags: None

Leave a comment: