My JDM wanna be E30 :D

[straight6pwr]

no drilling into car needed
http://r3vlimited.com/board/showthread.php?t=158967

thanks, might have to pick up a set of those for the rears.

[trackjunkie21]

Dude it took you 3 and a half hours to do the front brakes? WITH A FRIEND? How long does it take two fucktards to replace two rotors????

THREE AND A HALF FUCKING HOURS.

Jesus christ please buy a civic.

I'm with him on this. WTF were you doing? I replaced seized rotors with stripped bolts in less time.

[bimmer_E30]

looking at those mudflaps, would there be an easy way to mount them without drilling holes into the valance and completely destroying them?

I just drilled a hole in my rear valance. In case i dont like it, i have plastic caps that will fill it right in and prevent any kind of rust or somthing.

[kamotors]

looking at those mudflaps, would there be an easy way to mount them without drilling holes into the valance and completely destroying them?

no drilling into car needed

http://r3vlimited.com/board/showthread.php?t=158967

[HarryPotter]

Dude it took you 3 and a half hours to do the front brakes? WITH A FRIEND? How long does it take two fucktards to replace two rotors????

THREE AND A HALF FUCKING HOURS.

Jesus christ please buy a civic.

[ak-]

i will give a hint. 16X9's and will be wearing 225-40.....;)

but they dont make sportmaxx's in 9's

[straight6pwr]

looking at those mudflaps, would there be an easy way to mount them without drilling holes into the valance and completely destroying them?

[T3rd Ferguson]

i will give a hint. 16X9's and will be wearing 225-40.....;)

...says the guy who is too afraid to keep it because he wont drive it in winter.

grow up.

[Dirty e30]

Still
Slotted>Cross drilled.

Doesn't everyone know that?

I wouldn't argue with that, and I would never buy cross drilled rotors haha.
Just wondering how much of a concern it really is (aka playin devil's advocate lol)

[TDE30]

Broken English, entirely too much interweb lingo, half-assery galore; I might have been away from the forum for a little while but it still appears that bimmer_e30 comes from a long line of functioning retards.

:up:

Keep up the... work.

[siazul]

Hey nice car, I just bought an e30 with the same rims, 16x8, not sure of the offset, what suspension are you on? My e30 is slammed and I like the way yours is, not too low not too high

[bimmer_E30]

is that really much of a concern if you aren't tracking your car?
i like your car btws. what rims are you getting?

i will give a hint. 16X9's and will be wearing 225-40.....;)

[payney8]

Its all a wank anyway you need to be going hard enough to get the rotors/pads hot enough to need it. I.e. Tracking it or serious street runs. Its been discussed here before

[mamzak]

is that really much of a concern if you aren't tracking your car?
i like your car btws. what rims are you getting?

Still
Slotted>Cross drilled.

Doesn't everyone know that?

[Dirty e30]

crossdrilled rotors promote cracking when being heat cycled. just sayin'.

is that really much of a concern if you aren't tracking your car?
i like your car btws. what rims are you getting?