87' Delphin 325is LS1: Went to Paint

[airkhin]

saw this motor in person. absolute beast of a setup, cant wait to see it running! its what made up my mind to start workin on the m3 again. haha

[Rc 415]

Heat wrapped wiring

[truism]

your previous engine was a thing of pure beauty, but this lsx motor is looking pretty good too, not to mention the boost in power/weight. Very nicely done! Keep it up!

[Rc 415]

No, running the oil pressure gauge off my turbo setup actually

[kristov]

Did you use the LS1 oil pressure sensor?

[Rc 415]

I read this thread to motivate myself to do things faster. Well done.

I really appreciate that, thanks! Would like to meet up sometime man I admire your work as well :thumbsup:

[kronus]

I read this thread to motivate myself to do things faster. Well done.

[Rc 415]

I spy with my little eyes a zinno treat under the tarp.

You guys weren't supposed to see that.. Yet lol.

[evandael]

man. i can never get over how it right the LS engines look in there.

[M-technik-3]

I spy with my little eyes a zinno treat under the tarp.

[Rc 415]

Fuel rail is hooked up, Wiring is 90% done..

[Rc 415]

Brakes bled, clutch bled, engine has oil, trans has fluid, Radiator is in, look at all that clearance!!

[Rc 415]

Oh btw, cut the shifter hole bigger as per instructions and didn't even need to.. Oh well

[Rc 415]

I don't know if it differs from application to application, but the GTO guys (according to my buddy who owns a 06') have had issues where the engine covers (dem plastic bits) have a really bad habit of vibrating under normal use and sawing through one of the fuel lines that snakes under it. Done anything to avoid that?

Gto covers are a lot different, I have no fuel lines running under the corvette covers

[mohamed...]

his next mission is a ferrari v12 swap... great job!