87' Delphin 325is LS1: Went to Paint

[kristov]

Where did you buy the headers and do you have the part numbers?

[Rc 415]

Time to have some fun

[Rc 415]

Cam, push rods, and springs are in, computer has been tuned, got beauty covers.. Did all the wiring. Pretty much ready to go

[Rc 415]

Well it's happening soon. Car is on stands as of today. Broke my stock driveshaft launching too hard last week

[dmoney(AB)]

Awesome!!!!
I can't wait to see this thing on the road
And for you to feel the torque of a Chev v8.

[obes]

jesus! this is sweet!

[Rc 415]

[Rc 415]

Starting the cam swap. I decided to go with a Texas Speed & Performance 228r cam, beehive springs and chromoly pushrods. Good for a 50hp gain.






This engine is so clean inside it's Crazy!

[Rc 415]

Will do, your guide is great and the parts you made are high quality as well! Do you think I can fit 3" pipe from the headers? I wont be running cats, and I noticed 3" pipe fits pretty nice through the trans brace. I want to run 3" from each header to a 4" oval exhaust with a cutout or something. Also there are some parts that are missing in your master parts list that I found while reading though each section.

[garretvs]

Nice work! Keep it up with pics

[Rc 415]

Beaded up the pan







Got the correct headers



Ordered steering shaft solution


Got my wiring and relay/fuse setup




Shot of the corner where I'm stacking everything up

You can see the new rad behind the trans there too

[Rc 415]

Got me a set of headers

[Rc 415]

Got me a set of headers

[Cronopoulos]

Awesome progress, this makes me happy.

[Rc 415]

Oil pan is ready for some bead laying