NOR-CAL General Chat.

[smyleboyd]

Hey one of you should sell me a M20 or a M42 for my 2002. PM me if you got what i need.

[Cabriolet]

Hey one of you should sell me a M20 or a M42 for my 2002. PM me if you got what i need.

no, my 2 extra m20s are for me

[canakami]

Hey one of you should sell me a M20 or a M42 for my 2002. PM me if you got what i need.

If you find an M20 shortblock I have a head, haha.

[smyleboyd]

no, my 2 extra m20s are for me

If you dont sell me one ill put a M42 into it. ( that might convince you)

If you find an M20 shortblock I have a head, haha.

Okay ill keep that in mind. I have a friend that might need a head.

[toddness]

I have a long block m20 and a short block m20 and am 885 reconditioned head I am motivated to move....

[DRTSRFR]

yes and no. you can use an eta's, 325i and 318is. but not early 318's.

Early ETAs have no provision for ABS...;)

[Cabriolet]

If you dont sell me one ill put a M42 into it. ( that might convince you)



Okay ill keep that in mind. I have a friend that might need a head.

ok, i have a short block ill sell you for scrap value + oil pan value
it will need new bearings, rings, honing

[toddness]

ok, i have a short block ill sell you for scrap value + oil pan value
it will need new bearings, rings, honing

How much is scrap value on these? How bout a long block?

[Cabriolet]

How much is scrap value on these? How bout a long block?

$20 for crank and block. sell the head to people.
a full m20 engine should sell for $350 unrefresh and $2000 refreshed

[toddness]

Thx - anybody looking, I have these items and need out of my life fast (read as I am dealing). Hit me up.

[salvuhdor]

I need to look for the pig tails for my euro smileys. Where can I find these

[HerbReal]

I need to look for the pig tails for my euro smileys. Where can I find these

Or you can solder them on professionally with shrink wrap and some butt connectors. Otherwise, pelican is the place or on FS section

[e30vert]

i can weld,

So can I and I have a welder but its at my house in NV. Miller Mig 220. The point is moot though as Eric would have to cut his exhaust off to even attempt any repairs.

I'll cart the MIG down on my trailer if needed but it runs off 220 V . So unless there is a 220 V source then no welding.

I installed a 220 V outlet in my garage just for that purpose.

That blows! Flanges FTW! No flanges for the suck!

[e30vert]

Don't worry there gonna do it for me. Then bolt it back together with a plate and some screws

[e30vert]

ok, i have a short block ill sell you for scrap value + oil pan value
it will need new bearings, rings, honing

If he does not take it I may be interested.