If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Name: Jeremi S. McCullough Location: Renton, WA E30(s): 1988 mirage silver 325ix &
1991 black&white 325i M50-T
and just for shits and giggle, if your ever in the area and feel like stopping by or would like some help tinkering with the car your welcome to give me a call and use my shop.
cell (206)234-2685
(new euro rub strips on order, and barrowed the rims from the race car for a day :-D )
~bench press
~drill press
~bench grinder
~full air
~full rolling tool chest
~welder(mig non gas, lost job the day i was going to buy a miller gas feed :( )
pretty much a very well equiped garage.Only thing i wish i had was a lift, sad thing is the roof is to low and yes i found out the hard way...
When are you usually avaiable? Want to find an upcoming sunday to help me install some sway bars? I need to have the reinforcements welded for the rear and then just all the installation.
gimmie a call anytime from 8-9am to 9-10pm if i dont awnser im either asleep or i didnt hear it ring so leave me a mess. and or call me back in a few min 8)
Justin Bresee
Petaluma, CA (Also NorCal-ish) ;P
1990 325ic
To let it be known, on edit, I know I'm not PNW, but Clay posted so I thought why not join in lol
Comment