Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Send me your address, I have extras. Just go slow when you weld it; I warped the first one pretty bad and had to start over. I also don't know if the sender will actually display the level correctly...
-
Anywhere in that area will work. I had the power steering pump on but not that bracket it your second picture, when I mocked it up. I used the arms on my engine stand to bend the dipstick tube and get...
Leave a comment:
-
Thanks!! Lots of work but rewarding to see them on the motor, knowing I modified them. Engine is ready to go in. Time to push it into the corner and start engine bay work. Been procrastinating that...
- Likes 3
Leave a comment:
-
Thanks again adam.nonis!! Got those cam bolts installed. They are shallow and the exhaust side are super difficult to get a torx on. While I was in there I installed MILVs, that turned into a nightmare....
- Likes 3
Leave a comment:
-
- Likes 1
Leave a comment:
-
From reading up on the MSV70 DME it seems like the ECU takes care of the cruise function. It gets a speed signal on pin 17 of X60001, from DSC, but Nando can program it to accept the E30 speed from C101....Last edited by Striker01; 04-06-2024, 12:05 PM.
Leave a comment:
-
[QUOTE=adam.nonis;n10117486]
I have a set of (10) of these you can have Striker01. Just give me a mailing address. I got a set for my engine, but I have a different rev and don't need them. /QUOTE]...
Leave a comment:
-
Thanks for offering to send those to me. My address is 8503 N 153rd East Ave, Owasso, OK. 74055. Please let me know what you want for them. I'll paypal or cahshapp, whatever you prefer.
...
-
hoveringuy, I have the same bolts in your picture but the original recall part number is NLA. Seems BMW doesn't have a solution for these right now. The donor car VIN is in the 23V-707 recall. Another...
Leave a comment:
-
Yeah, I plan to bypass the IVM for that diag to ECU, no need to pass through it. I've never wired a swap, just want to understand the components.
Leave a comment:
-
Been geeking out on wiring stuff. Doesn't seem overly complicated but be nice to be certain of what I can and can't pull out of the harness before install. Couldn't find much on the IVM. Got the multimeter...
Leave a comment:
-
-
The stalk feels nice and secure with the trim on. Once I get the brake relay installed I can put the dash in, if I ever get it finished, and run the wires to...
- Likes 1
Leave a comment:
-
Having cruise and AC is a requirement for me and I couldn't find anything on converting the E30 switch to the single wire signal for MSV70. The next logical step was to order a Z4 stalk switch, Z4 brake...Last edited by Striker01; 03-24-2024, 10:17 PM.
Leave a comment:
No activity results to display
Show More
Leave a comment: