Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Did you replace / resurface the flywheel? Is the tang still there that the reference sensor uses? If new flywheel, is it the right one with the tang? When you replaced the reference and speed sensors,...
-
First, check the rotor, it is difficult, but not impossible to put it on wrong. Check you have the spark plug wires going to the correct spark plug. Is the crank position sensor connected and installed...
Leave a comment:
-
You could put a drop or two of WD40 or similar on the cable as it may be binding in the sleeve. Then, inside the drum, the lever mechanism may need to be worked free and cleaned up. Finally, the shoes...
- Likes 1
Leave a comment:
-
Do you have wiring diagrams for your car? I think you need to start moving "upstream" with a good multi-meter. If you drop power at fuse 17 (on my 85 diagram), then you need to go upstream...
Leave a comment:
No activity results to display
Show More
Leave a comment: