Just doing the conversion on my e30, engine is in, and wired up, but wont start, it just turns over without trying to fire.
When I had the engine in an e34, it had a 484 ECU/DME, this was swapped for a 404 ECU/DME. I had to cut wire to pin 66 on ECU/DME, and bridge pins 1 & 3 on EWS box under dash. It worked fine when in the 540. I only swapped the engine, and main engine harness, leaving the EWS parts on the 540 as I assume using a 404 ECU I dont need any of the EWS wiring.
This is how I have wired it:-
Anyone see if I have done anything wrong?
When I had the engine in an e34, it had a 484 ECU/DME, this was swapped for a 404 ECU/DME. I had to cut wire to pin 66 on ECU/DME, and bridge pins 1 & 3 on EWS box under dash. It worked fine when in the 540. I only swapped the engine, and main engine harness, leaving the EWS parts on the 540 as I assume using a 404 ECU I dont need any of the EWS wiring.
This is how I have wired it:-
Anyone see if I have done anything wrong?
Comment