If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi, I see that many of you have removed the oil cooler and installed the 11 112140435 pipe joint. Does anyone know do I need any kind of gasket/seal to screw the pipe joint to the block?
^^^not needed when converting to the eta filter setup. The only seal you need will come on the filter and seals right against the block. The tube just gets screwed tight to the oil passage.
^^^not needed when converting to the eta filter setup. The only seal you need will come on the filter and seals right against the block. The tube just gets screwed tight to the oil passage.
d'oh
you're right. i don't know how i read it when i first replied...
Comment