Do you guys normally put toe eccentric bolts with the nut pointing inside? Look like bolt will be blocked by the bushing this way but the nut will be somewhat accessible. Or there is a special tool to get in there when everything installed? I'm a little puzzled....This is for weld on toe kit. Thanks
Announcement
Collapse
No announcement yet.
Rear subrame toe adjusters
Collapse
X
-
I cut and welded up a couple of 19mm wrenches to get at them. And I think
I did a bit of metalwork to get clearance, as well.
As to keeping them in place, tighten the piss out of them. If that doesn't work, a tack of weld
usually does.
The Ireland serrated ones made sense to use on toe- it's usually something you only
have to set once, and then you don't want it to move...
tnow, sometimes I just mess with people. It's more entertaining that way. george graves
Comment
-
I never found the toe to change enough to matter on the street, so yes, try just
the camber adjustment first. I bet it'll work.
(figuring that you'll probably go from something like 1/16 toe in to 3/32nds)
tnow, sometimes I just mess with people. It's more entertaining that way. george graves
Comment
Comment