Ive read that the M52 wrist pin location is higher in the piston than the S50 US piston.. . Anyone have the scoop on this?
We are trying to use an M54 3.0 crank in an M52 block, We have a set of S50 rods and pistons.. The engine needs to be bored anyway due to an out of round cylinder.. so the larger s50 pistons would possibly be perfect, if they dont travel above the deck
We are trying to use an M54 3.0 crank in an M52 block, We have a set of S50 rods and pistons.. The engine needs to be bored anyway due to an out of round cylinder.. so the larger s50 pistons would possibly be perfect, if they dont travel above the deck
Comment