View Single Post
Old 12-06-2018, 04:20 PM   #32
HCMW Adam
Member
 
Join Date: Oct 2016
Location: Houston
Posts: 91
I have a waterjet at work, so I just used that to cut the filler panel. It still needed a little sanding to fit. The welding process was easy enough. After finishing the panel I had to cut out a bunch of rust outside the sunroof hole. After finishing that bit there was a bit of waviness in the roof. I am not satisfied with it. There is also a little bit of rust outside that area on the other side.

I plan to cut it all out, add some supports and do it again


Sent from my iPhone using Tapatalk
HCMW Adam is offline   Reply With Quote