Hello all. I have a few questions about O-Ring Block modifications
1) Is there a DIY somewhere that can be used as a guide for doing this job?
2) Is the block and head reusable again if the head has to come back off? Let me elaborate. If I decided to take the head off for upgrades later on down the road, is there any reason that the head would not be reusable? What about the block?
3) Where can I rent this tool from, and buy the o-ring itself?
4) Do you use a stock head gasket with this?
Thanks in advance guys
1) Is there a DIY somewhere that can be used as a guide for doing this job?
2) Is the block and head reusable again if the head has to come back off? Let me elaborate. If I decided to take the head off for upgrades later on down the road, is there any reason that the head would not be reusable? What about the block?
3) Where can I rent this tool from, and buy the o-ring itself?
4) Do you use a stock head gasket with this?
Thanks in advance guys
Comment