If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I got tired of being on my back under the car and under the dash. So I decided to do something standing up. I worked on getting the nitrous spray bar and meth injection installed.
I got tired of being on my back under the car and under the dash. So I decided to do something standing up. I worked on getting the nitrous spray bar and meth injection installed.
Well doesn't look like I'm going to make TX2k:(. The AN fittings a had welded to the blower lid started leaking. The same shop did the same crappy welding job on the heat exchanger inside the blower lid. I had this work done about 4 months ago and the shop would not stand by their work. I blame myself for 1. accepting the shit work 2. For not looking the shop up.
Anyway I found a awesome shop in Houston, Speed Lab Creations. I had those guys finish the work on the blower lid. Man what difference. I'm going to have these guys build my exhaust for me to. Tried looking around for other speed shops but everybody is booked because of TX2K. They will be able take my E30 after the event. Oh well no sense in rushing now.
Superb build so far. Glad to see you're taking your time and doing things right the first time. Those welds were haggard AF ^. Wish I would have been following the build up to this point could have chimed in a few times .
Superb build so far. Glad to see you're taking your time and doing things right the first time. Those welds were haggard AF ^. Wish I would have been following the build up to this point could have chimed in a few times .
Comment