I'm at this point. I've already removed the trans brace and also removed the nuts and bolts that attach to the driveshaft to allow the tranny to tilt and get some angle but the tranny isn't moving.
Do I need to remove all 6 of the nuts and bolts on the giubo, or should I loosen the motor mounts?
I'll be heading to Harbor Freight today to confirm if the tool is NLA, a new HF just opened by my house so it's not a huge waste of time to go
Do I need to remove all 6 of the nuts and bolts on the giubo, or should I loosen the motor mounts?
I'll be heading to Harbor Freight today to confirm if the tool is NLA, a new HF just opened by my house so it's not a huge waste of time to go
Comment