Announcement

Collapse
No announcement yet.

E36 M54 MS43 SWAP OBD don't connect

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    E36 M54 MS43 SWAP OBD don't connect

    Hello

    I have swapped a M54B30 engine from E39 530 into a E36 and re-flash the MS43 by MS43wiki ews delete file.
    Everything is well and engine start and running but i have a problem.

    DME don't connect to ISTA-D or INPA software by OBD2 connection.
    OBD2 pin 1-16 to 12v and 4-5-8 grounded ti chassis and 7 to 32 X60004.
    All wiring is ok.
    In X60004 Connector pin 24 is Brake light switch so grounded to chassis also pin 26 is to 12v ignition switch.

    So maybe the EWS delete file uncorrected?
    Last edited by Perfectmotorsport; 04-05-2018, 05:20 AM.

    #2
    Are you sure those pins are needed? Go to www.newtis.info and look up your car for the wiring schematic. If you are talking the throttle actuator/body, it only uses 6 wires.

    Comment

    Working...
    X