If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
formyhealth - 1991 318is Build Thread - now with 1000% more 1JZ-GTE
Too cool! I'll have to read through it. Did you go with the stock harness or use a plug and play from someone?
I initially set out to reuse the stock harness as it was running perfectly in my SC300. In my thread you can see I had begun stripping it down.
In the end I went with a Wiring Specialties harness.
Is using the stock harness doable? In my opinion yes, and I had a lot of it figured out and connected to the e30 bulkhead connector. I just started finding cracked wires etc.
I initially set out to reuse the stock harness as it was running perfectly in my SC300. In my thread you can see I had begun stripping it down.
In the end I went with a Wiring Specialties harness.
Is using the stock harness doable? In my opinion yes, and I had a lot of it figured out and connected to the e30 bulkhead connector. I just started finding cracked wires etc.
That makes a lot of sense really, I am about 90% confident that I've found all the wires on the loom that I need to connect. I probably have an easier go at it since I'm directly connecting it to a standalone relay panel.
Did some more stuff, steering column is fabricated, mounted the throttle pedal to the garagistic pedal mount and started on primer. Sent from my SM-G973U1 using Tapatalk
Comment