Originally posted by driftingminor913
View Post
Announcement
Collapse
No announcement yet.
M60/62 Turbo kit....in the works
Collapse
X
-
M60/62 Turbo kit....in the works
I built my M60 E30 and I can tell you that with the pipeline your are making there's no way it will fit. You might be able to fit a small turbo on the passenger side but you can forget on the drivers side. Turbo setups have been done in the past but this engine will run much better with a SC set up and will be a lot more reliable too.
Sent from my iPad using Tapatalksigpic
323i MTEC1
Z3 coupe
E60 M5
Comment
-
Snapped some photos. Keep in mind may radiatior isn't in place. That's going to eat up space in front of the engine.
About 3.5" from top of the exhaust port to the grain rail. Should mean you can't go beyond that distance away from the engine on a line parrellel to the ground.
It's the same thing on the drivers side.
Took a shot of the front passenger area, just holding up the tape so you have something to scale roughly.
Here is a shot down the passenger side.
Frame rails at the front measured a little over 27"
Comment
Comment