This is my home made rear wheel bearing tool that I made from parts you can get at lowes or home depot , someone asked me to post it up so here it is . it is 3/8 threaded rod aprox. 18 inches long , (2) 2 inch galvanized pipe caps , and asorted 3/8 washers in diferent thicknesses and sizes , (2) 3/8 nuts ,and a 30 mm socket.
It has been about 8 years since I used it last , so I can't recall exactly how I used it , but it should be self explanatory once you are ready to press the bearing out , use the socket to press the bearing into one of the caps , it should fit , I know it isn't too pretty but it saves you some money for a tool you may use once or twice. good luck.
It has been about 8 years since I used it last , so I can't recall exactly how I used it , but it should be self explanatory once you are ready to press the bearing out , use the socket to press the bearing into one of the caps , it should fit , I know it isn't too pretty but it saves you some money for a tool you may use once or twice. good luck.
Comment