If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Looking for a driveshaft to finish my 24V swap with a ZF. It needs to be from an E36 328i/M3 manual with the three bolt flange in the front and four bolt flange in the rear. I'm located in 19002 for shipping estimates.
Originally posted by Melon
Engine work takes patience and finesse.
Suspension work takes anger, a big fucking hammer, and a torch.
Comment