If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I suppose that any hunk of metal can be machined, but my understanding about resurfacing dual mass flywheels is that resurfacing them can cause balance issues. I am not certain whether this is a valid reason or not.
you can resurface a dual mass flywheel. Find a legitimate engine building machine shop local to you. I have seen mine resurface dual mass units with no issues.
A dual mass flywheel that has been re-surfaced can also be re-balanced.
Comment