R3VLimited Forums

Go Back   R3VLimited Forums > E30 Technical Forums > Engine & Drivetrain > M30 & Other Swaps

Reply
 
Thread Tools
Old 01-30-2015, 12:43 PM   #136
kusserwagon
Noobie
 
Join Date: Dec 2012
Location: germany
Posts: 36
almost done

E30 touring

M30b35 from an e34
Schmiedmann headers
No transmission yet
Garagistic mounts
M20 wiring

All I've done is replace gaskets and clean /paint parts
Keeping as cheap as possible for the moment.

Other couple things is
E36 sport seats (w/factory fire extinguisher)
Nardi steering wheel

Working on suede headliner and electric sunroof install

Gonna bring this baby stateside as soon as my time in Germany is over.

Will post pics once I load them to my computer, my phone doesn't want to let me.
Attached Images
 
kusserwagon is offline   Reply With Quote
Old 01-30-2015, 04:04 PM   #137
nighthawk
Member
 
nighthawk's Avatar
 
Join Date: Oct 2013
Location: Franklin, TN
Posts: 69
Hey guys I am in Franklin TN.
Ive got a 1991 325i that now has a m30b35 that I daily.

M30b35 from (91 e34 535i)
179 ecu
G260 5 speed trans from same e34
E30 shift linkages
Garagistic mounts
M20 rubber mounts
E28 radiator
No firewall modifications
E30 m20 wiring harness
E34 washer fluid reservoir
Stock A/C fan up front
E34 Air Intake
Replaced most gaskets and rubbers
E46 Steering Rack
E36 Tie Rods
Working Cruise Control and Power Steering
3.25 LSD from e28
E30 m20 manual drive shaft
Flange swap on transmission
Stock flywheel and Clutch
Stock Headers
Downpipes to Y-pipe 3in back
Used Toyota Catalytic Converter and Muffler
Borla 3" muffler at the end
H&R Sports with Bilstein Sports
Avid.1 AV-11 16x8 et +15
205/50/16 Kumho Ecsta AST
Rear fenders rolled

To Do:
Front Control Arms
Offset Bushings
Sway Bar Links
E90 top hats
Alignment
Possible Valve adjustment

In the future:
Working A/C
R134 Converted




nighthawk is offline   Reply With Quote
Old 05-08-2015, 03:49 AM   #138
The München Monster
Advanced Member
 
The München Monster's Avatar
 
Join Date: Dec 2012
Location: Auckland, New Zealand
Posts: 150


Auckland New Zealand

1988 M30B35
Getrag 262 late 70s four speed
E28 535 radiator
M20 mounts
Not sure about headers or driveshaft
Everything else is stock 318i stuff. Even brakes.
Superlow springs but stock shocks.
Cam is suspected of being aftermarket, lumpy idle
Stock open diff 3.91
but goes like hell, lots of fun. This is my first car and was auto m10 when i bought it.
__________________
Celebrating 30 years.
1986 E30 Coupe, assembled in Munich, West Germany, 7/7/86. M10 5 Speed cruisin' through time and space
The München Monster is offline   Reply With Quote
Old 07-25-2015, 11:43 AM   #139
EatsHondas
Grease Monkey
 
EatsHondas's Avatar
 
Join Date: Sep 2012
Location: Kennesaw, GA
Posts: 398
ECU/DME
-MegaSquirt 2 - V3.0 Board
-Speed Density Tune w/ 2.5 bar Onboard MAP Sensor
-Stock M30B35 Crank Position Sensor
-Innovate MTX-L Wideband
-E36 3-Wire Throttle Position Sensor
-Closed Loop Idle Control with Stock 3-Wire Valve
-E30 Late Model M20B25 Engine Harness with E30 C191 connector

Engine
-1988 735i M30B35
-Free-Flow Intake + Pod Filter (No AFM/Airbox)
-Stock E34 Headers/Collectors > Y-Pipe with O2 bung > 2.5" single > eBay Resonator 2.5in/out > Magnaflow 12158
-Garagistic Engine Mount Arms
-Stock M20B25 Engine Mounts

Cooling
-Stock M30B35 Water Pump/Hoses/T-Stat
-16" SPAL Pusher w/ custom mounts (manual and auto on/off with stock E30 wiring)
-Stock E28 535i Radiator

Fuel
-Batch Fire Injection (2 groups of 3 injectors, 1 transistor per group)
-Bosch 440cc Green Top Injectors
-Stock M30B35 Pressure Regulator
-Stock E30 325i Pump

Ignition
-Stock M30B35 Ignition Coil
-Stock M30B35 Plugs (NGK Variant)
-M20B25 Magnecor Plug Wires
-Stock M30B35 Cap/Rotor

Drivetrain
-1991 535i G260 w/ M20B25 G260 Output Flange
-Stock Z3 1.9 Shifter Rod
-Stock/Unmodified 325i Shift Linkage
-Stock/Unmodified 325i Driveshaft
-Stock E28 M5 Clutch/Pressure Plate/Throw-Out Bearing
-Lightened Stock M30B34 Single-Mass Flywheel
-Stock E30 M20B25 Master and Slave Cylinders
-Stock/Unmodified 325i Transmission Crossmember
-E30 3.73 Limited Slip Diff

Suspension/Steering
-Konig Rollers w/ 15mm spacers all around + hubcentric rings (15x7.5 ET32) (Unmodified Fenders)
-Hankook Ventus V2 Concept H457 (205-50-15)
-H&R Race Springs/Bilstein Sport Shocks
-E30 M3 Eccentric Front Control Arm Bushings
-Stock Sway Bars/Bushings
__________________
1989 325i Sedan
5-Speed Swapped
M30B35 Swapped
MegaSquirt 2 V3.0

Last edited by EatsHondas; 09-05-2017 at 02:34 PM. Reason: Update/Organization
EatsHondas is offline   Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 02:59 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC