Hi,
So I have 3 wilwood masters, (260-10371 and 260-10372) and they use 1/8-27 NPT thread fitting for the lines on the outlet side.
The problem I am running into is when I use the Wilwood Brake Line Fittings and Adapters 220-13125 they end up tightening at wrong angles.
One would face UP, one would face DOWN and one would go LEFT vs. RIGHT.
I don't want to risk ruining the MC by over tightening these with trying to get the ends to face ONE way.
What's the best course of action here? I tried "starting" to thread them differently, and even switched them around, but can't get them to line up.
Is there another fitting that I can use , perhaps something like using this first "https://www.summitracing.com/parts/wil-220-0628/overview/" and then "L" shaped adapter?
I really don't want to add a bunch of adapters, but need the outlets to face ONE way to better route the lines for my v8 swap.
Thanks!
So I have 3 wilwood masters, (260-10371 and 260-10372) and they use 1/8-27 NPT thread fitting for the lines on the outlet side.
The problem I am running into is when I use the Wilwood Brake Line Fittings and Adapters 220-13125 they end up tightening at wrong angles.
One would face UP, one would face DOWN and one would go LEFT vs. RIGHT.
I don't want to risk ruining the MC by over tightening these with trying to get the ends to face ONE way.
What's the best course of action here? I tried "starting" to thread them differently, and even switched them around, but can't get them to line up.
Is there another fitting that I can use , perhaps something like using this first "https://www.summitracing.com/parts/wil-220-0628/overview/" and then "L" shaped adapter?
I really don't want to add a bunch of adapters, but need the outlets to face ONE way to better route the lines for my v8 swap.
Thanks!
Comment