Got a new slave cylinder and bleeding it before I put it back in. And it doesn't seem to operate right. I bleed it and just fluid comes out so I think it would be set. But once I pump the petal there's still nothing there its not going in and out. Theres also no petal at all, just goes right to the floor. And the the rubber piece around the rod ballons up like it's getting filled and about to pop. I dont know if its filling with fluid or air.
Now why is that filling up like that?
and it should operate just the same out of the car,
With a firm petal and moving in and out smoothly as if it was in the tranny right?
Now why is that filling up like that?
and it should operate just the same out of the car,
With a firm petal and moving in and out smoothly as if it was in the tranny right?
Comment