So i have these parts left from my engine rebuild.
The last parts that have some damage will be explained. I actually don't expect to sell them. The rest of the parts are ready to run.
lets start by a complete set of 24v valves. They fit any e36 6cyl engine, but they came off an s52 if you're wondering.
$60 for intake valves(Two are brand spanking new ones from pelican parts)
$50 for exhaust side (12 good + 1 brand spanking new from pelican parts)
add $20 i'll throw in springs and retainers/locks.
$10 Valve Cover Gasket
$3/5shipped for Throttle body Gasket. Use w obdII TB.
$85shipped for timing tool and alignment pin. Brand new ~ used once.
24v Hydraulic lifters. One set. Later model type. All good and soaked in oil $75.
Lastly a damaged head and block. The story goes that i dropped a valve at RRR and well damaged the head and block. The broken tab on the block was from a previous owner. I rocked this engine for two years at the track, drift events with no problems, there's like 8 bolts holding the tranny to the block. Enough said. Pictures:
Head: good and flat. Just needs a new seat on one valve. $XX (obo)
Block: the center deepest gash is <0.005-0.008" deep. A good hone will take care of it. Bore 86.4mm (s52) block. $XX (obo)
Post, shoot pm's, call me. I have UPS and USPS stop by my work everyday so i can get stuff out the door very quickly. Thanks for looking,
Luis R
The last parts that have some damage will be explained. I actually don't expect to sell them. The rest of the parts are ready to run.
lets start by a complete set of 24v valves. They fit any e36 6cyl engine, but they came off an s52 if you're wondering.
$60 for intake valves(Two are brand spanking new ones from pelican parts)
$50 for exhaust side (12 good + 1 brand spanking new from pelican parts)
add $20 i'll throw in springs and retainers/locks.
$10 Valve Cover Gasket
$3/5shipped for Throttle body Gasket. Use w obdII TB.
$85shipped for timing tool and alignment pin. Brand new ~ used once.
24v Hydraulic lifters. One set. Later model type. All good and soaked in oil $75.
Lastly a damaged head and block. The story goes that i dropped a valve at RRR and well damaged the head and block. The broken tab on the block was from a previous owner. I rocked this engine for two years at the track, drift events with no problems, there's like 8 bolts holding the tranny to the block. Enough said. Pictures:
Head: good and flat. Just needs a new seat on one valve. $XX (obo)
Block: the center deepest gash is <0.005-0.008" deep. A good hone will take care of it. Bore 86.4mm (s52) block. $XX (obo)
Post, shoot pm's, call me. I have UPS and USPS stop by my work everyday so i can get stuff out the door very quickly. Thanks for looking,
Luis R
Comment