So every auction on ebay talks about rear wheel bearings on their application charts as 9/85 and newer models. I did some looking once upon a time and came up with the following:
according to skf's parts catalog : linky
The rear wheel bearing to before 9/1985 is GRW230,
CONST DBALLG1
GEN-MSG1 SKF# BA2B309639BA
GEN-MSG2 DOUBLE SEALED BALL BEARING
ID 1.5354
OD 2.8346
PRI A
PRI-PRNT Y
RAMS 4310
SMAC 5041
TYPE C9
WEIGHT 1.2000
WIDTH 1.4567
after 9/1985 its GRW231
CONST DBALLG1
GEN-MSG2 SKF# BAHB311424A
ID 1.6535
OD 2.9528
PRI A
PRI-PRNT Y
RAMS 4310
SMAC 5041
TYPE C9
WEIGHT 1.3550
WIDTH 1.4567
I have a pre 9/85 car and was wondering what the difference between the two bearings were. It seems from this that the inner and outer diameters are different sizes.
Looking at this realoem link, the hub and all the little pieces except the outer two are different.
Does that mean my subframe is different?
How about my half-shafts/axles/whatever u call 'em?
Are the smaller, pre 1985 bearings a liability if I put say 250hp to the ground?
Anyone?
according to skf's parts catalog : linky
The rear wheel bearing to before 9/1985 is GRW230,
CONST DBALLG1
GEN-MSG1 SKF# BA2B309639BA
GEN-MSG2 DOUBLE SEALED BALL BEARING
ID 1.5354
OD 2.8346
PRI A
PRI-PRNT Y
RAMS 4310
SMAC 5041
TYPE C9
WEIGHT 1.2000
WIDTH 1.4567
after 9/1985 its GRW231
CONST DBALLG1
GEN-MSG2 SKF# BAHB311424A
ID 1.6535
OD 2.9528
PRI A
PRI-PRNT Y
RAMS 4310
SMAC 5041
TYPE C9
WEIGHT 1.3550
WIDTH 1.4567
I have a pre 9/85 car and was wondering what the difference between the two bearings were. It seems from this that the inner and outer diameters are different sizes.
Looking at this realoem link, the hub and all the little pieces except the outer two are different.
Does that mean my subframe is different?
How about my half-shafts/axles/whatever u call 'em?
Are the smaller, pre 1985 bearings a liability if I put say 250hp to the ground?
Anyone?
Comment