Massachusetts 1989 ix Project

[MSGGrunt]

Intake manifold pulled off and at the powder coater for a blast and clear powder coat finish. All bits are pulled off and a new timing belt is going on and valves adjusted.

Just ordered over $500.00 in transfer case/engine seals, all new radiator/heater hoses, gaskets, distributor cap, rotor, plugs and plug wires and other small bits.

[MSGGrunt]

My 1986 325e will be getting a new water pump and timing belt and then it's back on the iX project since I finally broke down and bought a rear driveshaft which was the one big part holding up my 5-speed swap. Hopefully the U-joint is in good condition.