The rear of my tranny is leaking pretty bad. I have a bunch of stuff to do under there anyhow, (guibo, driveshaft support bearing, ssk) so I should do this at the same time.
Has anyone done this themselves before or is it a shop job? Do I need any special tools to change the seal?
Also, does someone have the part numbers to order, I just cannot seem to find them on my ETK.
Thanks.
Has anyone done this themselves before or is it a shop job? Do I need any special tools to change the seal?
Also, does someone have the part numbers to order, I just cannot seem to find them on my ETK.
Thanks.