If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
GB for me depends on t3h cost. You know everybody on r3v are cheap asses lol These allow you to use m3 wheel bearings on stock non-m strut housings?
Will
RIP e30 (brilliantrot '91 325i) 11/17/06 Byebye: 8/21/07
Welcome e30 (brilliantrot '90 325is) 12/23/06
DaveCN = Old Man
My signature picture was taken by ME! Not by anyone else!
Originally posted by george graves
If people keep quoting me in their sig, I'm going to burn this motherfucker down.
RIP e30 (brilliantrot '91 325i) 11/17/06 Byebye: 8/21/07
Welcome e30 (brilliantrot '90 325is) 12/23/06
DaveCN = Old Man
My signature picture was taken by ME! Not by anyone else!
Originally posted by george graves
If people keep quoting me in their sig, I'm going to burn this motherfucker down.
RIP e30 (brilliantrot '91 325i) 11/17/06 Byebye: 8/21/07
Welcome e30 (brilliantrot '90 325is) 12/23/06
DaveCN = Old Man
My signature picture was taken by ME! Not by anyone else!
Originally posted by george graves
If people keep quoting me in their sig, I'm going to burn this motherfucker down.
i'm assuming this is a sleeve that fits over the stock spindle? I was under the impression that the e36 hub centerbore was larger than the e30 hub centerbore. I talked to my friend who is a machinist a couple years ago about this, he said that the sleeve would need to be precision ground on both the outside, and inside to make it work properly. He said you could get away with just the outside if you had to though.
Either way- props to whoever on finally figuring it all out.
Comment