If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If your in a hurry go eBay headers, they are cheap and work.
M10 stock manifolds between 2002-e21-e30 are a different flange where the down pipe connects, and if so then your only looking at a 2 year window that motor was an option so the amount left is slim
For what it's worth, I had a decent sized crack in my m10 manifold, right in the center. I was unable to locate a decent replacement so I used some of that QuikSteel stuff.
I took the manifold off the car, grinded down to clean metal about 1/2" on each side of the crack. I applied it and cured it closely following the directions. It's been about 2 months and everything is still rock solid. It's good to 2400 degree it's much better suited than jb weld.
Comment