So i try to start the car and it immediately dies. Listed below is everything i have done so far
Okay so replaced a bunch of gaskets and sensors on the car trying to clear up a rough idle issue. I replaced intake manifold gaskets, throttle body gasket as well as the one on the side of the throttle body, all the vacuum lines for the brake booster and the check valve and the part that plugs into the intake elbow, timing belt and tensioner, camshaft seal, crankshaft seal, intermediate shaft seal, bitch pipe upper and lower orings, oil filter housing orings, i replaced fuel filter, injectors, fuel lines, cap rotor, plugs, wires, coil. Throttle body was cleaned as well as the ICV. I tested the resistance of the ICV and throttle position sensor and they both checked out. Any ideas?
Okay so replaced a bunch of gaskets and sensors on the car trying to clear up a rough idle issue. I replaced intake manifold gaskets, throttle body gasket as well as the one on the side of the throttle body, all the vacuum lines for the brake booster and the check valve and the part that plugs into the intake elbow, timing belt and tensioner, camshaft seal, crankshaft seal, intermediate shaft seal, bitch pipe upper and lower orings, oil filter housing orings, i replaced fuel filter, injectors, fuel lines, cap rotor, plugs, wires, coil. Throttle body was cleaned as well as the ICV. I tested the resistance of the ICV and throttle position sensor and they both checked out. Any ideas?
Comment